8BVI0110HWDS.000-3 B&R Electronic Components
Part#:8BVI0110HWDS.000-3
Manufacturer:B&R
Product Lifecycle:Active
Get a quick Quote!
ACOPOSmulti3 SafeMOTION EnDat 2.2 inverter module, 15.1 A, AS, wall mounting, 2 axes, optimized for applications with decentralized, computationally intensive open-loop and closed-loop control requirements
Check out the 8BVI0110HWDS.000-3 B&R price in the box on the right side or send a quick quote.
Product Details
- Weight5.3 kg
- Dimensions Depth Wall mounting 263 mm
- Terminal connection cross section Approbation data UL/C-UL-US 30 to 10
- Encoder power supply Protective measures Short-circuit proof Yes
- Encoder power supply Protective measures Overload-proof Yes
- Temperature Operation Maximum 55°C
- Temperature Operation Nominal 5 to 40°C
- Terminal connection cross section Approbation data CSA 28 to 10
- Dimensions Height 317 mm
- Installation elevation above sea level Maximum 4000 m
- Dimensions Width 106.5 mm
- Terminal connection cross section Flexible and fine-stranded wires With wire end sleeves 0.25 to 4 mm²
- Relative humidity Operation 5 to 85%
- Relative humidity Transport Max. 95% at 40°C
- Relative humidity Storage 5 to 95%
- Temperature Transport -25 to 70°C
- Installation elevation above sea level Nominal 0 to 500 m
- Temperature Storage -25 to 55°C
- Permissible mounting orientations Standing horizontally No
- Permissible mounting orientations Horizontal, face up Yes
- Switching delay Falling edge 53 µs ±0.5 µs (digitally filtered)
- Switching delay Rising edge 52 µs ±0.5 µs (digitally filtered)
- Switching threshold Low <5 V
- Permissible mounting orientations Hanging vertically Yes
- Input voltage Maximum 30 VDC
- Input voltage Nominal 24 VDC
- Switching threshold High >15 V
- Electrical isolation Input - Input Yes
- Synchronous serial interface Data transfer rate 6.25 Mbit/s
- Electrical isolation Input - Inverter module Yes
- Synchronous serial interface Signal transmission RS485
- Encoder power supply Load capacity 350 mA
- Encoder power supply Output voltage Typ. 12.5 V
- Electrical isolation Encoder - ACOPOSmulti No
- Max. motor line length depending on switching frequency Switching frequency 20 kHz 10 m
- Protective measures Undervoltage monitoring Yes
- Max. motor line length depending on switching frequency Switching frequency 10 kHz 25 m
- Protective measures Open-circuit monitoring Yes
- Protective measures Overload and short-circuit protection Yes
- Variant Shield connection Yes
- Max. motor line length depending on switching frequency Switching frequency 5 kHz 25 m
- Protective measures Overload protection Yes
- Variant U, V, W, PE Connector
- Reduction of continuous current depending on installation elevation Starting at 500 m above sea level 1.51 Aeff per 1000 m
- Protective measures Short-circuit and ground fault protection Yes
- Reduction of continuous current depending on switching frequency Switching frequency 20 kHz 0.15 A/K (starting at -38°C)
- Reduction of continuous current depending on switching frequency Switching frequency 10 kHz 0.19 A/K (starting at 29°C)
- Reduction of continuous current depending on switching frequency Switching frequency 5 kHz No reduction
- Power dissipation depending on switching frequency Switching frequency 20 kHz [1.66 * IM² + 21 * IM + 380] W
- Power dissipation depending on switching frequency Switching frequency 5 kHz [0.33 * IM² + 11 * IM + 90] W
- Voltage Nominal 750 VDC
- Certifications KC In preparation
- Power dissipation depending on switching frequency Switching frequency 10 kHz [0.97 * IM² + 9.5 * IM + 170] W
- Output voltage DC bus voltage (UDC): 315 to 800 VDC 24 VDC ±6%
- Certifications UL cULus E225616; Power conversion equipment
- Certifications EAC Yes
- Output voltage DC bus voltage (UDC): 260 to 315 VDC 25 VDC * (UDC/315)
- Module width 2
- Certifications CE Yes
- Certifications Functional safety Yes (openSAFETY)
- Overvoltage category per EN 61800-5-1 III
- Degree of protection per EN 60529 IP20
- Pollution degree per EN 61800-5-1 2 (non-conductive pollution)
- Discharge capacitance 0.44 µF
- Input current at nominal voltage Approx. 10 mA
- Modulation compared to ground potential Max. ±38 V
- Circuit Sink
- Max. encoder cable length 100 m ; Depends on the cross section of the power supply wires in the encoder cable
- Max. power consumption per encoder interface PSMC[W] = 19 V * IEncoder[A]
- Status indicators UP/DN LEDs
- Connections 9-pin female DSUB connector
- Type EnDat 2.2
- Encoder monitoring Yes
- Response threshold for undervoltage monitoring 24 VDC -2% / -4%
- Max. switching frequency 0.5 Hz
- Response threshold for open-circuit monitoring Approx. 0.5 A
- Max. extinction energy per switching operation 3 Ws
- Extinction potential Approx. 30 V
- Max. internal resistance 0.3 Ω
- Continuous current 2.1 A
- Output voltage 24 VDC +5.8% / -0.5%
- Possible switching frequencies 5 / 10 / 20 kHz
- Max. output frequency 598 Hz
- Terminal cable cross section dimension of shield connection 12 to 22 mm
- Insulation stress of the connected motor per IEC TS 60034-25:2004 Limit value curve A
- Peak current per motor connection 37.7 Aeff
- Nominal switching frequency 5 kHz
- Fuse protection 250 mA (slow-blow) electronic, automatic reset
- Continuous current per motor connection 15.1 Aeff
- Continuous power per motor connection 11 kW
- Variant ACOPOSmulti backplane
- Cooling and mounting type Wall mounting
- Continuous power consumption 22.3 kW
- Quantity 2
- Max. power consumption 32 W + PSMC1 + PSMC2 + P24 V Out + PHoldingBrake(s)
- Input voltage 25 VDC ±1.6%
- Slots for plug-in modules 2
- B&R ID code 0xAA19
- DC bus capacitance 660 µF
- Input capacitance 23.5 µF
Product condition
ORIGINAL PACKAGING
SURPLUS ORIGINAL PACKAGING - 100% unused and in original packaging
Related documents 8BVI0110HWDS.000-3 Specs
1-year warranty
Get a quick Quote!
Request a quote, and we will send you price and availability within minutes.
Select Qty:
Average response time: 11 minutes
By purchasing this item, you agree to the Terms & Conditions
Quotebeam is NOT an authorized distributor of B&R
Shipping and Delivery Worldwide
calculate costs and time
Secure Payment Processing
with money back guarantee
1 year warranty
on all parts
Responsive Customer Support
we're here to help!
Need more details?
Feel free to chat with us or check our FAQ
B&R Disclaimer:
The product is unused surplus. Quotebeam is not an authorized surplus dealer or affiliate for the Manufacturer of this product. Products may feature older date codes or be from an earlier series than what is currently available from the manufacturer or authorized dealers. Because Quotebeam is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many B&R Controls products will have firmware already installed, Quotebeam makes no representation as to whether a Controls product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Quotebeam also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from B&R, its distributors, or any other source. Quotebeam also makes no representations as to your right to install any such firmware on the product. Quotebeam will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
Relevant products
Do you have questions?
We’re here for you ✨
We are a proud member of:
