1271966 Phoenix Contact Electrical Wires & Cables

Product Details

• Application
  For charging electric vehicles (EV) with alternating current (AC)
• Note
  A protective cap is supplied as standard for the AC contacts.
• Width
  90 mm
• Ambient temperature (operation)
  -40 °C ... 80 °C
• Maximum charging power
  26 kW
• Number of power contacts
  5 (L1, L2, L3, N, PE)
• Rated current of power contacts
  32 A AC
• Temperature monitoring
  AC contacts: PTC system (DIN EN 60738-1)
• Restrictions to mounting position
  Only 0 to 90 degree frontal inclination possible, see figure
• Withdrawal force
  < 100 N
• Design line
  Generation 4
• Material
  Plastic
• Flammability rating
  V0
• Minimum bending radius
  15 mm
• Maximum voltage for locking detection
  12 V
• Design
  Generation 4
• External cable diameter
  1.6 mm -0.2 mm
• Operating voltage
  12 V (Typical power supply at the motor)
• Reverse current of the motor
  max. 1.5 A
• Tolerance at the sensor with the recommended measured current
  ±5K
Note on the connection method
Crimp connection, cannot be disconnected
Height
90 mm
Degree of protection
IP55 (plugged in; when plugged in and ready to operate, the degree of protection is only ensued if both plug-in components are original products from Phoenix Contact or suitable standard-compliant products)
Rated voltage for power contacts
480 V AC
Rated voltage for signal contacts
30 V AC
Insertion/withdrawal cycles
> 10000
Mounting hole diameter
6.70 mm (ø)
Customer variations
On request
Cable structure
4 x 0.5 mm²
Cable weight
7 kg/km
Max. dwell time with reverse current
1 s
Service life insertion cycles
> 10000 load cycles
Type of sensor
PTC chain
Standards/regulations
DIN˽EN 60738-1
Charging mode
Mode 2, 3
Depth
111.4 mm
Ambient temperature (storage/transport)
-40 °C ... 85 °C
Type of charging current
AC 3-phase
Rated current for signal contacts
2 A
Insulation resistance of neighboring contacts
> 200 MΩ
Type of signal transmission
Pulse width modulation with modulated Powerline communication according to ISO/IEC 15118 / DIN SPEC 70121
Mounting position of the locking actuator
Right-side
Housing color
black
Material surface of contacts
Ag
External sheath, color
orange
Single wire, color
black PP/CS
Number of positions of theconnectors
4
Cable length
1 m
Mechanical emergency release
available
Temperature range
-40 °C ... 130 °C
Type
Locking actuator right
Charging standard
Type 2
Conductor length
2 m (AC cables)
Max. altitude
4000 m (above sea level)
Number of signal contacts
2 (CP, PP)
Resistor coding
4.7 kΩ (between PE and PP)
Insertion force
< 100 N
Required mounting screws
M6
Screws included in the scope of delivery
none
Locking type
Locking in the inserted state with a locking mechanism
Cable resistance
≤ 37.1 Ω/km
Outer sheath, material
PVC
Possible power supply range at the motor
9 V ... 16 V
Typical motor current for locking
0.25 A
Pause time after entry or exit path
3 s
Recommended measured current
≤ 1 mA (Umax= 16 V DC)
ECLASS 11.0
27144706
Recommended adaptation time
600 ms
Lock recognition
available
ECLASS 10.0.1
27144706