1271830 Phoenix Contact Electrical Wires & Cables

Product Details

• Application
  For charging electric vehicles (EV) with alternating current (AC)
• Note on the connection method
  Crimp connection, cannot be disconnected
• Charging mode
  Mode 2, 3
• Standards/regulations
  DIN˽EN 60738-1
• Conductor length
  2 m (AC cables)
• Maximum charging power
  8 kW
• Rated current for signal contacts
  2 A
• Rated voltage for signal contacts
  30 V AC
• Temperature monitoring
  AC contacts: PTC system (DIN EN 60738-1)
• Design line
  Generation 4
• Customer variations
  On request
• Outer sheath, material
  PVC
• Operating voltage
  12 V (Typical power supply at the motor)
• Max. dwell time with reverse current
  1 s
• Lock recognition
  available
• Note
  A protective cap is supplied as standard for the AC contacts.
• Ambient temperature (operation)
  -40 °C ... 80 °C
• Type of charging current
  AC single-phase
• Number of signal contacts
  2 (CP, PP)
• Type of signal transmission
  Pulse width modulation with modulated Powerline communication according to ISO/IEC 15118 / DIN SPEC 70121
Insertion force
< 100 N
Mounting position of the locking actuator
Right-side
Flammability rating
V0
Cable structure
4 x 0.5 mm²
Single wire, color
black PP/CS
Reverse current of the motor
max. 1.5 A
Type of sensor
PTC chain
ECLASS 10.0.1
27144706
Type
Locking actuator right
Charging standard
Type 2
Width
90 mm
Max. altitude
4000 m (above sea level)
Number of power contacts
5 (L1, L2, L3, N, PE)
Resistor coding
4.7 kΩ (between PE and PP)
Restrictions to mounting position
Only 0 to 90 degree frontal inclination possible, see figure
Screws included in the scope of delivery
none
Material
Plastic
Locking type
Locking in the inserted state with a locking mechanism
Minimum bending radius
15 mm
Possible power supply range at the motor
9 V ... 16 V
Number of positions of theconnectors
4
Recommended adaptation time
600 ms
Cable length
1 m
ECLASS 11.0
27144706
Design
Generation 4
Height
90 mm
Depth
111.4 mm
Degree of protection
IP55 (plugged in; when plugged in and ready to operate, the degree of protection is only ensued if both plug-in components are original products from Phoenix Contact or suitable standard-compliant products)
Rated voltage for power contacts
250 V AC
Insertion/withdrawal cycles
> 10000
Mounting hole diameter
6.70 mm (ø)
Material surface of contacts
Ag
External cable diameter
1.6 mm -0.2 mm
Cable weight
7 kg/km
Maximum voltage for locking detection
12 V
Pause time after entry or exit path
3 s
Mechanical emergency release
available
Tolerance at the sensor with the recommended measured current
±5K
Ambient temperature (storage/transport)
-40 °C ... 85 °C
Rated current of power contacts
32 A AC
Insulation resistance of neighboring contacts
> 200 MΩ
Withdrawal force
< 100 N
Required mounting screws
M6
Housing color
black
Cable resistance
≤ 37.1 Ω/km
External sheath, color
orange
Typical motor current for locking
0.25 A
Service life insertion cycles
> 10000 load cycles
Recommended measured current
≤ 1 mA (Umax= 16 V DC)
Temperature range
-40 °C ... 130 °C