1078802 Phoenix Contact Relays

1078802 Product Details

• Note
  FBS 2-6... plug-in bridge for the input side (A2) and FBS-2-8... plug-in bridge for the output side (11/21)
• Ambient temperature (operation)
  -40 °C ... 70 °C
• Typical release time
  10 ms
• Width
  16 mm
• Maximum altitude
  ≤ 2000 m
• Input voltage range in reference to UN
  see diagram
• Operating voltage display
  Yellow LED
• Min. switching current
  100 mA (at 12 V DC)
• Operating mode
  100% operating factor
• Connection method
  Push-in connection
• Conductor cross section solid
  0.14 mm² ... 1.5 mm²
• Standards/regulations
  EN 50178
• Identification
  ISA-S71.04. G3 Harsh Group
• ETIM 6.0
  EC001437
• Height
  96 mm
• Nominal input voltage UN
  12 V DC
• Typical response time
  8 ms
• Power dissipation for nominal condition
  0.41 W
• Interrupting rating (ohmic load) max.
  264 W (at 24 V DC, observe contact derating)
• Switching capacity
  2 A (at 24 V, DC13)
Stripping length
8 mm
Designation
Corrosive gas test
ECLASS 11.0
27371601
ETIM 7.0
EC001437
Type of note
Notes on operation
Depth
75 mm
Typical input current at UN
34 mA
Protective circuit
Free-wheeling diode Damping diode
Type of switch contact
Single contact
Limiting continuous current
6 A
Test voltage
4 kV AC (50 Hz, 1 min., winding/contact)
Mechanical service life
3x 107 cycles
Assembly instructions
In rows with zero spacing
Rated surge voltage
6 kV
Pollution degree
2
Utilization restriction
EMC: class A product, see manufacturer's declaration in the download area
Ambient temperature (storage/transport)
-40 °C ... 85 °C
Degree of protection
RT II (Relay)
Coil voltage
12 V DC
Contact material
AgSnO
Maximum inrush current
80 A (for 20 ms)
Switching capacity min.
1200 mW
Mounting position
any
Conductor cross section flexible
0.14 mm² ... 1.5 mm²
Rated insulation voltage
250 V AC
ECLASS 10.0.1
27371601
ECLASS 9.0
27371601
Contact type
1 N/O contact
Maximum switching voltage
250 V AC/DC (The separating plate PLC-ATP should be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules. Potential bridging is then carried out with FBST 8-PLC... or ...FBST 500...)
Minimum switching voltage
12 V AC/DC (at 100 mA)
Connection name
Contact side
Conductor cross section AWG
26 ... 16 (solid)
Overvoltage category
III
Insulation
Safe isolation, reinforced insulation
China RoHS
Environmentally Friendly Use Period = 50 years

Product condition