2906990 Phoenix Contact UPS (DC)

2906990 Product Details

• Depth
  125 mm
• Installation distance right/left (passive)
  0 mm / 0 mm (POut ≥50% )
• Installation distance right/left (active)
  5 mm / 5 mm (POut ≥50% )
• Installation distance top/bottom (passive)
  40 mm / 20 mm (POut ≥50% )
• Max. permissible relative humidity (operation)
  ≤ 95 % (at 25 °C, non-condensing)
• Reverse polarity protection
  yes
• Internal input fuse
  no
• Switch-over time
  0 ms
• Energy storage device connection in series
  no
• Dynamic Boost (IDyn.Boost)
  10 A (5 s)
• End-of-charge voltage (temperature-compensated)
  25 V DC ... 32 V DC
• Temperature compensation (configurable)
  42 mV/K
• Charge characteristic curve
  IU0U
• Conductor cross section solid min.
  0.2 mm²
• Conductor cross section AWG max.
  12
• EMC requirements for noise immunity
  EN 61000-6-1
• Standards/regulations
  IEC 61010-1 (SELV)
• Output
  1 kV (Test Level 3 - symmetrical)
• Depth with alternative assembly
  37 mm
• Installation distance top/bottom (active)
  50 mm / 50 mm (POut ≥50% )
Ambient temperature (operation)
-25 °C ... 70 °C (> 60 °C Derating: 2.5 %/K)
Installation height
≤ 4000 m
Fixed backup threshold
22 V DC
Efficiency
typ. 98 %
Output voltage range
19 V DC ... 28 V DC (UOUT = UBAT - 0.3 V DC)
Max. capacity
40 Ah
Temperature sensor
yes
Life expectancy (electrolytic capacitors)
224011 h
Single conductor/terminal point, stranded, with ferrule, min.
0.2 mm²
Conductor cross section AWG min.
30
Low Voltage Directive
Conformance with Low Voltage Directive 2014/35/EC
Test field strength
300 A/m
Frequency range
50 Hz ... 60 Hz
Discharge in air
15 kV (Test Level 4)
Frequency
0 Hz
Width
35 mm
Installation distance right/left (active, passive)
0 mm / 0 mm (POut ≤50 %)
Inflammability class in acc. with UL 94 (housing / terminal blocks)
V0
Input voltage
24 V DC
Electric strength, max.
35 V DC (Protected against polarity reversal)
Voltage drop, input/output
0.3 V DC
Short-circuit-proof
yes
Width with alternative assembly
123 mm
Installation distance top/bottom (active, passive)
40 mm / 20 mm (POut ≤50 %)
Degree of protection
IP20
Climatic class
3K3 (EN 60721)
Ambient temperature (storage/transport)
-40 °C ... 85 °C
Input voltage range
18 V DC ... 30 V DC
Height
130 mm
Height with alternative assembly
130 mm
Inrush current
≤ 7 A (≤ 4 ms)
Input
1 kV (Test Level 3 - symmetrical)
I/O/S
asymmetrical
ECLASS 10.0.1
27040705
ECLASS 5.1
27242213
UNSPSC 18.0
39121011
Criterion B
Temporary impairment to operational behavior that is corrected by the device itself.
ETIM 6.0
EC000382
UNSPSC 13.2
39121004
UPS connection in series
no
Energy storage device connection in parallel
Yes, 5 (observe line protection)
Nominal capacity (without additional charger)
0.8 Ah ... 40 Ah
Conductor cross section solid max.
2.5 mm²
Tightening torque max
0.6 Nm
Electromagnetic compatibility
Conformance with EMC Directive 2014/30/EU
Conducted interference
EN 61000-4-6
Voltage
10 V (Test Level 3)
Power frequency magnetic field
EN 61000-4-8
ETIM 7.0
EC000382
UNSPSC 20.0
39121011
Degree of pollution
2
UPS connection in parallel
no
Charging current (configurable)
max. 1.5 A
IQ-Technology
yes
Connection method
Screw connection
Conductor cross section flexible min.
0.2 mm²
Stripping length
6.5 mm
EMC requirements for noise emission
EN 61000-6-3
Identification
IEC 61010-1
Electrostatic discharge
EN 61000-4-2
Static Boost (IStat.Boost)
6.25 A
Charging time
150 min. (3.4 Ah)
Conductor cross section flexible max.
2.5 mm²
UNSPSC 19.0
39121011
Ambient temperature (start-up type tested)
-40 °C
Switch-on time
max. 3 s
No-load proof
yes
Environmental protection directive
RoHS Directive 2011/65/EU
Single conductor/terminal point, stranded, with ferrule, max.
2.5 mm²
Designation
CB scheme
Electromagnetic HF field
EN 61000-4-3
Surge voltage load (surge)
EN 61000-4-5
Signal
1 kV (Test Level 2 - asymmetrical)
ECLASS 11.0
27040705
ECLASS 9.0
27040705
Battery technology
VRLA, VRLA-WTR, LI-ION
Selective Fuse Breaking (ISFB)
30 A (15 ms)
Buffer time
25 min. (3.4 Ah)
MTBF (IEC 61709, SN 29500)
> 2065000 h (25 °C)
Weight
0.5 kg
Tightening torque, min
0.5 Nm
Standard designation
Safety extra-low voltage
Contact discharge
8 kV (Test Level 4)
Additional text
DC, 60 s
REACh SVHC
Lead 7439-92-1
Comments
Criterion A
Fast transients (burst)
EN 61000-4-4
Criterion A
Normal operating behavior within the specified limits.
UNSPSC 21.0
39121011

Product condition