8063638 Festo Manifold Dispensers

8063638 Product Details

• Type of mounting
  Optionally: With internal thread and centering sleeve
• Duty cycle
  50 % (max. switch-on time 1 s)
• Electrical connection
  9-pin Sub-D
• Storage temperature
  -20 °C ... 70 °C
• Note on dosing precision
  Depending on the configuration, environment and application
• Typical dosing precision
  <1% CV for volumes >5 µl <2.5% CV for volumes between 1-5 µl
• Application note
  See application note (available on the support portal at festo.com)
• Length of dosing needle
  30 mm
• Electrical power consumption
  1.8 W
• Max. switching frequency
  4 Hz
• Shock resistance
  Shock test with severity level 2 as per FN 942017-5 and EN 60068-2-27
• Degree of protection
  IP30
• Valve function
  2/2, closed, monostable
• Mounting position
  Any
• Width dimension
  9 mm
• Internal volume
  113 µl valve with fluid connections
• Note on dosing volume
  Depending on the configuration, environment and application
• Note on switching time off
  Depending on the configuration, environment and application
• Note on degree of protection
  In mounted state
• Type code
  VTOE
Permissible voltage fluctuations
+/- 10 %
Temperature of medium
5 °C ... 50 °C
Actuation type
Electrical
Materials in contact with the media
ETFE High-alloy stainless steel
Material number for dosing needle
1.4301
Water flow rate at max. operating pressure
1300 µl/s
Information on medium
Observe resistance of materials that come into contact with media
Contamination level
2
Min. dosing volume
3 µl
Nominal width
0.8 mm
Nominal operating voltage DC
24 V
Fluid connector
8x UNF1/4-28
Note on fluid connector
Fitting enclosed for pneumatic tubing with 3 mm outside diameter
Material of dosing needle
High-alloy stainless steel
Nominal width of dosing needle
0.6 mm
Operating pressure
0 bar ... 0.5 bar
Nominal altitude of use above sea level
<= 2000 m NHN
Relative air humidity
0 - 95 % Non-condensing
Medium
Liquid media
On switching time
7 ms
Sealing principle
Soft
Reset method
Mechanical spring
Corrosion resistance class (CRC)
0 - No corrosion stress
Ambient temperature
5 °C ... 40 °C
Switching time off
2 ms
Note on power consumption
Specification per pneumatic valve
Product weight
220 g
Note on switching frequency
Dependent on the ambient temperature and installation state
Note on switching time on
Depending on the configuration, environment and application
Type of control
Direct
Vibration resistance
Transport application test with severity level 2 as per FN 942017-4 and EN 60068-2-6
Note on materials
Contains paint-wetting impairment substances RoHS-compliant

Product condition

Related documents 8063638 Specs