1202485 Festo Pneumatic Actuators

1202485 Product Details

• Adjustment range of swivel angle
  0 deg ... 270 deg
• Position sensing
  For proximity sensor With integrated angle measurement system
• Min. travel speed
  50 deg/s
• Shortest positioning stroke
  5° when positioning 15° for Soft Stop
• Mounting position, positioning
  Any
• Piston diameter
  63 mm
• Cushioning
  Elastic cushioning rings/pads at both ends
• Measuring principle of linear potentiometer
  Analog
• Max. swivel frequency at 6 bar
  1 Hz
• Typical positioning time, short-stroke, horizontal
  0.36/0.55 s
• Max. operating voltage DC
  42 V
• Nominal operating voltage DC
  10 V
• Corrosion resistance class (CRC)
  0 - No corrosion stress
• Max. mass moment of inertia, vertical
  0.6 kgm²
• Product weight
  6900 g
• Output signal
  Analog
• Pneumatic connection
  G1/4
• Stop lever material
  Wrought aluminum alloy Anodized
• Note on materials
  Free of copper and PTFE RoHS-compliant
• Material of cylinder barrel
  Wrought aluminum alloy
Type code
DSMI
Swivel angle
0 deg ... 272 deg
Operating pressure for positioning/soft stop
4 bar ... 8 bar
Typical positioning time, long stroke, horizontal
0.64/1 s
Max. current consumption
4 mA
Permissible voltage fluctuations
< 1 %
Continuous shock resistance to DIN/IEC 68 Part 2-82
Tested as per severity level 2
Min. mass moment of inertia, horizontal
0.03 kgm²
Angular resolution
≤ 0.1 deg
Soft Stop end position repetition accuracy
< 0.2 deg
(Fixed) stop material
Steel
Housing material
Wrought aluminum alloy Anodized
Material of plug housing
PA-reinforced
Stroke reduction in the end positions
5 °
Mounting position, Soft Stop
Horizontal
Design
Drive shaft on ball bearings Rotary vane
Max. travel speed
2000 deg/s
Connection resistance
5 kOhm
Max. short-time slider current
10000 µA
CE marking (see declaration of conformity)
As per EU EMC directive
Vibration resistance to DIN/IEC 68 Part 2-6
Tested as per severity level 2
Max. axial force
500 N
Min. mass moment of inertia, vertical
0.03 kgm²
Linear potentiometer electrical connection
4-pin
Material of measuring system housing
Wrought aluminum alloy Anodized
Vane material
PET-reinforced
Recommended contact current
< 1 µA
Connection resistance tolerance
20 %
Operating medium
Compressed air as per ISO 8573-1:2010 [6:4:4]
Impact energy in the end positions
0.1 J
Max. radial force
500 N
Theoretical torque at 6 bar
40 Nm
Independent linearity
0.0025
Repetition accuracy, Soft Stop intermediate position
+/- 2 deg
Type of mounting
With internal thread
Measuring system coupling material
NBR
Mode of operation
Double-acting
Information on operating and pilot media
Operation with oil lubrication not possible
Degree of protection
IP65 as per IEC 60529
Ambient temperature
-10 °C ... 60 °C
Max. mass moment of inertia, horizontal
0.6 kgm²
Positioning repetition accuracy
+/- 0.3 deg
Cable length
30 m
Drive shaft material
Steel Nickel-plated
Feather key material
Steel

Product condition

Related documents 1202485 Specs