1078803 Phoenix Contact Relays

1078803 Product Details

• Utilization restriction
  EMC: class A product, see manufacturer's declaration in the download area
• Ambient temperature (storage/transport)
  -40 °C ... 85 °C
• Typical response time
  8 ms
• Operating voltage display
  Yellow LED
• Maximum inrush current
  80 A (for 20 ms)
• Min. switching current
  100 mA (at 12 V DC)
• Test voltage
  4 kV AC (50 Hz, 1 min., winding/contact)
• Connection name
  Contact side
• Stripping length
  8 mm
• Pollution degree
  2
• Type of note
  Notes on operation
• Ambient temperature (operation)
  -40 °C ... 70 °C
• Typical input current at UN
  34 mA
• Height
  89 mm
• Degree of protection
  RT II (Relay)
• Nominal input voltage UN
  12 V DC
• Coil voltage
  12 V DC
• Type of switch contact
  Single contact
• Switching capacity
  2 A (at 24 V, DC13)
• Mounting position
  any
Conductor cross section flexible
0.5 mm² ... 4 mm²
Standards/regulations
EN 50178
Overvoltage category
III
ECLASS 11.0
27371601
Note
FBS 2-6... plug-in bridge for the input side (A2) and FBS-2-8... plug-in bridge for the output side (11/21)
Depth
75 mm
Input voltage range in reference to UN
see diagram
Contact type
1 N/O contact
Maximum switching voltage
250 V AC/DC (The separating plate PLC-ATP should be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules. Potential bridging is then carried out with FBST 8-PLC... or ...FBST 500...)
Limiting continuous current
6 A
Assembly instructions
In rows with zero spacing
Conductor cross section solid
0.5 mm² ... 4 mm²
Conductor cross section AWG
20 ... 10 (solid)
Designation
Corrosive gas test
China RoHS
Environmentally Friendly Use Period = 50 years
ETIM 6.0
EC001437
Width
16 mm
Maximum altitude
≤ 2000 m
Typical release time
10 ms
Protective circuit
Free-wheeling diode Damping diode
Contact material
AgSnO
Switching capacity min.
1200 mW
Mechanical service life
3x 107 cycles
Connection method
Screw connection
Conductor cross section flexible (2 conductors with same cross section)
0.5 mm² ... 2.5 mm²
Rated insulation voltage
250 V AC
Insulation
Safe isolation, reinforced insulation
ETIM 7.0
EC001437
Power dissipation for nominal condition
0.41 W
Minimum switching voltage
12 V AC/DC (at 100 mA)
Interrupting rating (ohmic load) max.
264 W (at 24 V DC, observe contact derating)
Operating mode
100% operating factor
Conductor cross-section solid (2 conductors with same cross section)
0.5 mm² ... 2.5 mm²
Torque
0.5 Nm ... 0.6 Nm
Rated surge voltage
6 kV
Identification
ISA-S71.04. G3 Harsh Group
ECLASS 10.0.1
27371601
ECLASS 9.0
27371601

Product condition