1078686 Phoenix Contact Relays

1078686 Product Details

• Height
  96 mm
• Depth
  75 mm
• Degree of protection
  RT II (Relay)
• Protective circuit
  Reverse polarity protection Polarity protection diode
• Contact type
  1 N/O contact
• Contact material
  AgSnO
• Interrupting rating (ohmic load) max.
  264 W (at 24 V DC, observe contact derating)
• Switching capacity
  2 A (at 24 V, DC13)
• Connection name
  Contact side
• Conductor cross section AWG
  26 ... 16 (solid)
• Rated surge voltage
  6 kV
• Identification
  ISA-S71.04. G3 Harsh Group
• ECLASS 11.0
  27371601
• ETIM 6.0
  EC001437
• Width
  16 mm
• Maximum altitude
  ≤ 2000 m
• Typical response time
  8 ms
• Nominal input voltage UN
  24 V DC
• Operating voltage display
  Yellow LED
• Type of switch contact
  Single contact
Min. switching current
100 mA (at 12 V DC)
Limiting continuous current
6 A
Assembly instructions
In rows with zero spacing
Stripping length
8 mm
Conductor cross section flexible
0.14 mm² ... 1.5 mm²
Pollution degree
2
China RoHS
Environmentally Friendly Use Period = 50 years
ECLASS 5.0
27371600
ECLASS 9.0
27371601
Type of note
Notes on operation
Ambient temperature (storage/transport)
-40 °C ... 85 °C
Typical input current at UN
18 mA
Coil voltage
24 V DC
Note regarding the switch contact
With tungsten leading contact
Maximum switching voltage
250 V AC/DC
Maximum inrush current
165 A (20 ms)
Operating mode
100% operating factor
Mounting position
any
Conductor cross section solid
0.14 mm² ... 1.5 mm²
Standards/regulations
EN 50178
Overvoltage category
III
ECLASS 10.0.1
27371601
ECLASS 6.0
27371600
Utilization restriction
EMC: class A product, see manufacturer's declaration in the download area
Note
The system installer must ensure the touch protection of the product (at voltages > 25 V AC/60 V DC). The product is a built-in device without protection against direct contact.
Ambient temperature (operation)
-40 °C ... 70 °C
Input voltage range in reference to UN
see diagram
Typical release time
10 ms
Power dissipation for nominal condition
0.43 W
Minimum switching voltage
12 V (at 100 mA)
Switching capacity min.
1200 mW
Test voltage
4 kV AC (50 Hz, 1 min., winding/contact)
Mechanical service life
3x 107 cycles
Connection method
Push-in connection
Designation
Corrosive gas test
Insulation
Safe isolation, reinforced insulation
ECLASS 5.1
27371600
ECLASS 7.0
27371601
ETIM 7.0
EC001437

Product condition