8034238 Festo Pneumatic Components

8034238 Product Details

• Type code
  EMCA
• Protective function
  I²t monitoring Software end position detection
• Display
  LED
• Nominal rotary speed
  3100 1/min
• KC characters
  KC EMC
• Rotor position sensor measuring principle
  Magnetic
• Controller operating mode
  PWM MOSFET power output stage PI current regulator
• Safety integrity level (SIL)
  Safe torque off (STO)/SIL 2
• Max. rotational speed
  3500 1/min
• Characteristics of digital logic outputs
  Freely configurable in some cases Not galvanically isolated
• Note on ambient temperature
  Above an ambient temperature of 20 °C, the power must be reduced by 1.75% per °C.
• Permissible axial shaft load
  60 N
• Proof test interval
  20 y
• Communication profile
  CiA402 FHPP
• Switching logic at outputs
  PNP (positive switching)
• Rotor position sensor
  Absolute encoder, single-turn
• Safety function
  Safe torque off (STO)
• Diagnostic coverage
  90 %
• Max. positive test pulse with 0 signal
  10000 µs
• Nominal current
  6.9 A
Max. number of positioning sets
64
Certificate issuing authority
German Technical Control Board (TÜV) 01/205/5514.00/16 UL E331130
Permissible voltage fluctuations
+/- 20 %
Storage temperature
-25 °C ... 70 °C
Ambient temperature
0 °C ... 50 °C
Performance Level (PL)
Safe torque off (STO)/category 3, performance level d
Hardware fault tolerance
1
Motor nominal power
120 W
SFF safe failure fraction
> 90 %
Peak current
10.2 A
Shock resistance
Shock test with severity level 2 as per FN 942017-5 and EN 60068-2-27
Certification
RCM compliance mark c UL us - Recognized (OL)
PFD
1.86E-5
Logic input specification
Based on IEC 61131-2
Braking resistor, external
6 Ohm
DC nominal voltage
24 V
Parameterization interface
Ethernet
Motor peak power
158 W
CE marking (see declaration of conformity)
As per EU EMC directive as per EU machinery directive
Corrosion resistance class (CRC)
1 - Low corrosion stress
Degree of protection
IP54
Rotor mass moment of inertia
0.175 kgcm²
Max. current of digital logic outputs
100 mA
Max. negative test pulse on 1 signal
600 µs
Protocol
CANopen
Rotor position sensor resolution
12 bit
Vibration resistance
Transport application test with severity level 2 as per FN 942017-4 and EN 60068-2-6
Relative air humidity
0 - 95 % Non-condensing
Nominal torque
0.37 Nm
Number of digital logic inputs
2
Type of mounting
Screwed tightly With through-hole
Peak torque
0.85 Nm
Product weight
1900 g
Number of digital logic outputs 24 V DC
2
Ethernet, supported protocols
TCP/IP
Note on materials
Contains paint-wetting impairment substances RoHS-compliant
Permissible radial shaft load
100 N
PFH
1.0E-9
Characteristics of logic input
Galvanically connected to logic potential
Input switching logic
PNP (positive switching)
Work range of logic input
24 V

Product condition

Related documents 8034238 Specs